Tutorial – Cracking Windows Password And Recovery using CMD

Cracking Windows Password And Recovery using CMD if you forget your windows account password, but you can sign in as guest you can use this way to get your password back

1. run cmd

2. type “net user “username” *” type without ” in the front and back

3. you will be prompt a new password

4. retype it

walla you got your account back!

 

For Cracking Windows Password And Recovery using CMD You need to login to Guest Account to make a new account from CMD.
For more Cracking Windows Password, Don’t forget to Read our Password Cracking Series.

A command prompt is a command you issue to your computer using a built-in program.

To change a computer password using Microsoft Command Prompt, follow these instructions. 1. Open command prompt: To do this just click or press the windows start button on your PC and type in command prompt…then click the command prompt icon when it shows or hold the windows start button and press R to open the windows run menu then type in cmd to open command prompt 2.To change a user’s password at the command prompt, log on as an administrator and type: net user user_name * /domain When you are prompted to type a password for the user, type the new password, not the existing password. After you type the new password, the system prompts you to retype the password to confirm. The password is now changed.
Alternatively, you can type the following command: net user user_name new_password When you do so, the password changes without prompting you again. This command also enables you to change passwords in a batch file.
Non-administrators receive a “System error 5 has occurred. Access is denied” error message when they attempt to change the password.

If you wanna Look Up your WiFi Password whom you’re connected to then you should use this command.

Step one

Go to command prompt, click start up menu on your system, click RUN, type Cmd, and click ok to open the command prompt

Step two

inside the command prompt, type the following

netsh wlan show networks
mode = bssid(it will show all the available wifi network, take note of the names)

Step 3

To connect to the wifi network, type the following

netsh wlan connect
name= (put the name of wifi your system detect)
e.g net wlan connect
name = (thehacktoday)

Step 4

press enter to connect

Step 5

To disconnect it, type

netsh wlan disconnect

Step 6

To save it type : netsh wlan export profile name = thehacktoday( not by name but change it to the name of the detected wifi)

Back to top button
Close